Yoshimura R&D of America, Inc.

TRS Muffler Clamp Stainless/Titanium 8x12x12

TRS Muffler Clamp Stainless/Titanium 8x12x12 - Main image
$28.46 $37.95 In stock

Category: Pièces de rechange pour entretien

Les colliers de silencieux ne sont peut-être pas la pièce la plus compliquée de votre échappement Yoshimura, mais vous en avez quand même besoin pour serrer les points de connexion de votre système. Vous ne trouvez pas celui qu'il vous faut ? Appelez-nous au 800-634-9166 ou envoyez-nous un e-mail à [email protected].

Avant de payer

Les moyens de paiement et le total final s’affichent au paiement.

Quand part la commande

Prévoyez le temps de préparation et de transport.

Standard Shipping: Préparation (jours ouvrés) 0–1; Transport (jours ouvrés) 7–15.

Express Shipping: Préparation (jours ouvrés) 0–1; Transport (jours ouvrés) 7–15.

Voir les conditions
Demander un remboursement

Contactez la boutique avec votre numéro de commande pour demander un remboursement.

Contactez-nous pour connaître le délai de remboursement avant le retour.

Voir les conditions
Frais de livraison

Vérifiez le tarif pour votre destination et le service choisi.

Standard Shipping · États-Unis: 0,00 $US

Express Shipping · États-Unis: 3,99 $US

Voir les conditions
Retourner un article

Vérifiez les conditions avant de renvoyer un article.

États-Unis · Délai de retour (jours après réception): 30. Mode de retour: Par courrier. Frais de retour: À la charge du vendeur.

Voir les conditions

Customer Reviews (4.8 / 5 · 5 reviews)

Julian ★★★★★

Finally found a clamp that actually matches the stock hardware on my existing system—this one uses the same 8x12x12 sizing without any guesswork. The stainless finish feels solid and the threads engaged smoothly right out of the box.

Carter ★★★★★

The threads on this clamp are perfectly cut, so it snugged right down without any binding. Fits my 8x12 connection seamlessly, a solid piece for keeping the exhaust tight.

Brian E. ★★★★★

Putting this clamp on was a breeze—the stainless finish lined up perfectly with my exhaust midpipe. Even the threads felt smooth, which made tightening it down without stripping a relief. It’s holding solid after a few heat cycles, exactly what I needed.