What the BUILDER SERIES RS-3 CF Mini Muffler Kit Is
The BUILDER SERIES RS-3 CF Mini Muffler Kit is a carbon fiber and titanium muffler designed for mini bike builds. It weighs just 2.5 pounds and features the classic RS-3 elliptical shape. Yoshimura describes it as a limited-run piece — it hasn't been built in a few years and is no longer part of any current exhaust system, so the company made it available through the Builders Series for custom projects.
This kit is for builders who want a unique sound, looks, and performance on their mini bike. It is not a complete exhaust system; it is the muffler component only. Before you begin, confirm that your existing header pipe or exhaust system can accept a slip-on muffler of this style.
BUILDER SERIES RS-3 CF Mini Muffler Kit Key Facts
- BUILDER SERIES RS-3 CF MINI BIKE MUFFLER KIT: Weight just 2.5 pounds. Extremely light for a mini bike muffler, reducing unsprung weight and making installation easier.

BUILDER SERIES RS-3 CF MINI BIKE MUFFLER KIT - BUILDER SERIES RS-3 CF MINI BIKE MUFFLER KIT: Carbon fiber and titanium construction. Combines the heat resistance and strength of titanium with the lightweight, high-end look of carbon fiber.
- BUILDER SERIES RS-3 CF MINI BIKE MUFFLER KIT: RS-3 Elliptical shape. Classic Yoshimura profile that fits many mini bike builds and delivers a distinctive sound.
- BUILDER SERIES RS-3 CF MINI BIKE MUFFLER KIT: Proudly designed and made in the USA. Supports domestic manufacturing and consistent quality control.
Installation Steps
The following steps are based on general mini bike muffler installation practices. Always refer to your specific vehicle service manual for torque specs and safety procedures. The supplied information does not include step-by-step instructions from Yoshimura, so treat these as a guideline for a typical slip-on muffler install.
- 1. Prepare the bike: Park the mini bike on a stable, level surface and let the engine cool completely if it has been running. Disconnect the battery negative terminal to prevent accidental starting.
- 2. Remove the old muffler (if applicable): Loosen the clamp or bolts securing the existing muffler to the header pipe. Slide the old muffler off. If there is a gasket, inspect it for damage and replace if needed.
- 3. Fit the RS-3 CF muffler: Slide the BUILDER SERIES RS-3 CF muffler onto the header pipe. The elliptical shape should align with your bike's clearance. Do not fully tighten the clamp yet — leave it loose enough to rotate the muffler for final alignment.
- 4. Align and tighten: Rotate the muffler so it clears the rear tire, swingarm, and any bodywork. Once aligned, tighten the clamp to the manufacturer's recommended torque. Reconnect the battery.
- 5. Check for clearance: Spin the rear wheel by hand to confirm the muffler does not contact the tire or chain. Start the engine and listen for any rattles or leaks at the joint. If you hear a leak, tighten the clamp slightly or add a new gasket.
What the Catalog Does Not Settle
The supplied information does not include a specific clamp size, gasket type, or torque value for the RS-3 CF muffler. Because this is a Builders Series part intended for custom applications, you may need to source a compatible clamp or gasket based on your header pipe diameter. The catalog also does not confirm whether the muffler includes a spark arrestor or dB insert — check local noise regulations if required for your riding area.
This muffler is a limited-release item. Yoshimura notes it may go extinct again, so if you want one for your build, consider ordering while stock is available.


