Install a Fender Eliminator on Kawasaki KLX250S
By Yoshimura R&D of America, Inc. | Published: 2026-10-26
Category: Product Reviews
Step-by-step guide to installing a Yoshimura fender eliminator kit on a Kawasaki KLX250S. Clean up the rear end, relocate the license plate, and improve the look.
Quick Answer
Installing a Yoshimura fender eliminator kit on your Kawasaki KLX250S replaces the bulky stock fender with a precision laser-cut bracket, relocates the license plate, and integrates brighter LED lighting for a clean, off-road-ready rear end.
Why Replace the Stock Fender?
The stock rear fender on the KLX250S is large and utilitarian, designed for mud protection but visually cluttered. A fender eliminator kit tucks the license plate up under the tail, removes excess plastic, and gives the bike a sharper, more aggressive look.
The Yoshimura kit is model-specific for the KLX250S (2008-2020) and KLX300S/SM (2021-2023), so the bracket aligns perfectly with existing mounting points without drilling or modification.
What's in the Kit?
The Yoshimura Fender Eliminator Kit includes a stainless steel laser-cut bracket, a weather-tight LED license plate light, heat shrink solder sleeve butt connectors, and all necessary hardware. The bracket is designed for USA-spec plates (4" x 7") with standard hole spacing.
Installation Steps
- Disconnect the battery: Remove the negative terminal to prevent any accidental shorts while working with the tail light wiring. A common mistake is forgetting to disconnect the battery, which can blow a fuse or damage the LED light.
- Remove the stock fender and tail light: Unbolt the rear fender (usually 4 bolts) and disconnect the tail light and turn signal connectors. Set the stock parts aside. Keep the stock hardware in a bag in case you ever want to return to the original setup.
- Prepare the wiring for the new LED light: Use the supplied heat shrink solder connectors to join the new LED license plate light wires to the bike's tail light wires. Apply heat with a heat gun or lighter until the solder flows and the tubing shrinks. Do not use standard crimp connectors; the solder sleeves provide a much more reliable waterproof connection.
- Mount the new bracket: Position the laser-cut stainless steel bracket against the subframe mounting holes and secure it with the provided bolts. Torque to spec (typically 8-10 ft-lb, but check your service manual). Over-tightening can strip the subframe threads or crack the bracket. Use a torque wrench if available.
- Attach the license plate and light: Bolt the license plate to the bracket using the supplied hardware. Then mount the LED light housing above the plate, ensuring it points downward to illuminate the plate evenly. Make sure the plate holes align with the bracket slots before tightening fully. The kit is designed for USA plates with 4" x 7" dimensions.
- Test all lights and secure wiring: Reconnect the battery and test the tail light, brake light, and license plate light. Zip-tie any excess wiring to the subframe to prevent rubbing or snagging. If the LED light doesn't work, check polarity: LEDs are polarity-sensitive. Swap the wires if needed.
Product Details
- KLX250S/SF 08-20 / KLX300S/SM 21-23 Fender Eliminator Kit: The kit includes new Shrink Solder Connectors and an improved weather-tight light housing with a brighter LED light. It is proudly made in the USA. The heat shrink solder connectors create a durable, weatherproof electrical connection, and the brighter LED light ensures your license plate remains visible in low-light conditions.
KLX250S/SF 08-20 / KLX300S/SM 21-23 Fender Eliminator Kit
